Stop by the shop m-f 9-5 and sat 9-3 for all you service, parts and custom needs!
- Posted using BlogPress from my iPhone
Tuesday, March 29, 2011
Saturday, March 26, 2011
Hoodies are in!
If you are local swing by open today till 3:00 or call to order 35.00 plus ship
- Posted using BlogPress from my iPhone
- Posted using BlogPress from my iPhone
Thursday, March 24, 2011
Wednesday, March 23, 2011
Coming Soon
New design for the CSC hoodies. Should be in next week. Please email if you are interested for pre-buy info@chopshopcycles.com
Step 4
One everything is fit just final weld. Remember you can take measurements off of the motor mounts to the rear axle to make sure everything is square. Take you r time and it will look nice. If you have any questions please feel free to contact us.
Part 3
Here is a picture of the Chop Shop Cycles Hardtail ready to go.
Fish mouthing the up posts to ft the hardtail.
Locating the bottom rails to the old frame.
It is always easier to grind a little at a time. Fitting the tail section with this method is not an exact science, we have found that different years of XS's are different and we can't tell you just where to cut.
This is how the bottom lays in. The slugs will go in the frame in the location the directions say, you just need to fit the up post to this section by fish mouthing it also.
XS Hardtail with a twist...PART 1
For this hardtail conversion we are going to leave the center section in place. You may have seen this look on the XS650 Choppper Site before. I believe the Fong Bros are known for the look we call it our dominator hardtail.
Here you can seen the rough cut made to the frame, we trim it off at the seat hoop and just behind the up post for the controls . We will cut back more as we fit the Hardtail.
In this picture and the one below you can see the brace we use to keep everything square. We are cutting out the cross brace in the frame so you need to brace it or you will have trouble aligning it later.
Saturday, March 19, 2011
Subscribe to:
Posts (Atom)
