I am always seeing people post questions on forums about this. To install an Ironhead in a frame all you need to do is lay the motor on the primary side. Support the motor with a 4x4 block of wood so it doesn't lay to far over. Next swing the frame into place and bolt the rear lower frame mount with 3/8 fine thread bolts. Don't go over tight you may need a little play to get the front mount in place. Bolt the front up with the two mounts right side mount goes on the out side of the right frame rail left side mount goes on the inside of the left frame rail. Use your hardware don't forget the pipe spacers that go between the frame rails in the front two holes. Stand the frame up and you are good to go.
No comments:
Post a Comment